#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS INSTALL#
#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS MANUAL#
#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS FREE#

Indicated ports, restrict air pressure to no more than 40 PSI (276 kpa). When applying air pressure to the clutches using the Normal/expected vehicle performance at cruising speed

#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS FREE#

Transmission fluid is clean and free of excessive contamination A failed one-way clutch can be identified if all of the following conditions/symptoms exist: Torque converter stator one-way clutch should hold at idle and duringДЄcceleration. The PCM monitors clutch performance and will set one or more DTCs when an undesired slip is detected. Test for determining the health of the transmission clutches. This torque truncation, the stall test cannot be used as a diagnostic Truncate engine torque output when a stall condition exists. Prevent damage to transmission and driveline components, the PCM will Only perform the stall speed test with the engine and transmission at normal operating temperatures. If the engine speed exceeds maximum specified rpm, release the accelerator pedal immediately. Throttle (WOT) in any gear range for more than 5 seconds. If line pressure is low, do not carry out the stall test orДЄdditional transmission damage will occur. A clutch concern can be further diagnosed by performing the airД¬arry out the Line Pressure Test prior to the Stall Speed Refer to the ClutchДЄpplication Chart to determine which clutch is applied in each gear Pressure because of inoperative clutches. No-drive condition can exist even with correct transmission fluid Main pressure regulator valve stuck in spring compressed positionД«roken or missing main pressure regulator valve spring LOW at IDLE OR Does not change when commanding LINEDSD# up and down

#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS INSTALL#

When the pressure tests are complete, install the line pressure tap plug. If the line pressure is not within specification, see the Line Pressure Diagnosis Chart for possible sources. Monitoring LINE pressure while commanding LINEDSD# up and down. Raise engine RPM to 2000 RPM and verify LPC operation by Actual measured pressure should be within 10 PSI (69 kPa) of PID Using a diagnostic scan tool, monitor and compare the PID LINEDSD# to actual measured pressure. Start the engine and check the line pressure. NPT fitting is used, damage to the transmission case will occur. National Pipe Thread (NPT) fitting when installing a pressure gauge. The line pressure tap is an M10 X 1.00 thread. Torque: 10 Nm (88 lb-in)Д¬onnect the transmission fluid pressure gauge (307-004) to the line pressure tap using an M10 X 1.00 fitting. REFER to: Transmission Line Pressure Test (307-01A Automatic Transmission - 10-Speed Automatic Transmission вЂ“ 10R60, General Procedures). If available, refer to the Transmission Line Pressure Test general procedure to access the line pressure tap. This test verifies the line pressure is within specification.

#FORD DIAGNOSTIC TEST PROCEDURE SYMBOLS MANUAL#

Ford Explorer 2020-2022 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission - 10-Speed Automatic Transmission вЂ“ 10R60 / Diagnosis and Testing - Special Testing Procedures

Ford diagnostic test procedure symbols